Re: Cisco AP 2602 Auto Mode Configuration save

interface31 · ‎08-25-2021

Hi,

i have some Cisco i2602 in Auto Mode on a Cisco Catalyst 2960-c

Works with Fast Ethernet

Now i want to Change to Gigabit Switch.

Now i have the problem some AP no work, it looks like that the start but after some minutes

there are off.

There are 4 pair cable.

I check the cable crimping and looks ok.

Can i save the config from a working AP and load them to the other?

cu

marce1000 · ‎08-25-2021

- You may for instance first want to 1) Check the logs on the Catalyst 2960-c when the AP goes off 2) Check the interface status for the particular off-ap 3) Check port counters.

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

interface31 · ‎08-25-2021

No with the 2960-c it works all everything fine.

I want to upgrade to a faster Switch,

I try a Huawei Switch i got this faulty message when i test the ports.

Don´t know whats the problem, is this cable so bad for a Gigabit Switch?

cu