cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3808
Views
0
Helpful
4
Replies

Cisco AP 3602I convert from lightweight to Autonomous

khalon
Beginner
Beginner

Dear 

i try to convert AP Cisco 3602I from lightweight to Autonomous but when i change the mode for access point to upload the file from T FTP i cannot ping between Switch and Access point (Time Out).

thanks for your help 

4 Replies 4

Sandeep Choudhary
VIP Mentor VIP Mentor
VIP Mentor

try another laptop/pc(Also disable local firewall)

 

here are the methods:

https://www.youtube.com/watch?v=c70mOOpqMsg

https://www.speaknetworks.com/converting-cisco-wireless-access-point-lightweight-mode-autonomous-mode-vice-versa/

 

Regards

Dont forget to rate helpful posts

Dear ,

 

thanks for your support but my problem is when i reboot the AP to start upload the IOS i lose the ping between the switch and from switch i cannot see the AP this my problem 

Hi,

 

1. login to AP via CLI

2. Assign IP to BVI interface and Default gateway

3. Ping to Laptop from AP and vice versa

4. If ping is scuessful then strat the image transfer from laptop.

 

 

Regards

Dont forget to arte helpful posts

m.rana.ku
Beginner
Beginner

Hi,
Step by Step Process has been demonstrated How to of Convert Cisco Aironet 3602i Series Access Point from Lightweight to Autonomous version.

https://www.youtube.com/channel/UCmZZ2BNGXQH1HPS3uIVnr7A?sub_confirmation=1

https://youtu.be/O2qNFVZ-KRQ

 

Requirements:
1.TFTPd64 Server
2.Cisco IOS Software AP3G2-K9W7-M for (C3600 Series AP)
3.The Cisco AP and the Laptop with TFTP server must be in same network.

According to my network setup
Lightweight AP BVI1 IP address is 192.168.1.4
Laptop's IP address where TFTP server is installed 192.168.1.7 [Default Router IP]

 

First disconnect the ethernet cable from the AP then Press the Mode button and Put back the ethernet cable to the AP and hold the Mode button Untill flash light turns to umber and Once the Lightweight AP goes to online then apply the following commands to convert it to Autonomous version:

 

set IP_ADDR 192.168.1.4                   [According to my network setup]
set NETMASK 255.255.255.0             [According to my network setup]
set DEFAULT_ROUTER 192.168.1.7    [According to my network setup]
tftp_init
ether_init
flash_init
tar -xtract tftp://192.168.1.7/ap3g2-k9w7-tar.153-3.JH.tar flash:
dir flash
set boot flash:/ap3g2-k9w7-mx.153-3.JH/ap3g2-k9w7-mx.153-3.JH
set
boot

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: