ssh not working after Wireless Controller 5520 upgrade to 8.10.112.0, whereas Telnet and HTTPs is working fine.
Forum Posts
I am not sure what I have misconfigured but this only happens over the data center hosted FlexConnect controllers, any AP model. When I migrate an AP to the 9800 controller which is on code 17.3.3, the image always takes an hour to download to the AP...
Ya se que quizas sea una pregunta un poco absurda, pero no consigo cambiarla desde la intefaz web ni por comandos SSH... Alguien puede decirme como podria cambiar la ip de controller? la de gestion. Gracias!
Hi guys, The AP 3802E have 4 ports(A\B\C\D) to connect to the external antenna. My question is that can these four antennas can work independently, or in group? For examples, like A+B+C+D, or AB+CD?
I have two WLCs configured as N+1 redundancy.All access points are configured to use WLC1 as primary and WLC2 as secondary per "high availability settings" on each of access point.Some access points are joined to WLC2 though. How can I force them to ...
Hi All, Installing quite a few 9120ax access points on a 98040 SSO WLC's, an RTLS survey has been completed and DNA Spaces acquired. Question: Whats best practise for the actual physical position of the access point I.E. should all AP's be physically...
Hi Anyone can explain what is difference among enterprize, fastlane, guest and voice in auto qos in 9800 wlc. Thanks
Hi we have two commands for trusting dscp at switch port connected to AP. One is auto qos trust dscp and another is mls qos trust dscp. What is difference between the two commands in this situation? I think both have the same the effect, but the firs...
I am trying to upload a custom web auth login page to EWC runnning on C9115AXI. Is this possible as there does not seem to be an option?
Dear good afternoon, I have a question, is there any way to monitor the power supply to the standby equipment via SNMP? (Active -Passive) we are currently monitoring it through the VIP and one of the power supplies of the standby equipment failed and...
Hi, I need to clarify if possible config settings for mobility between 9800 AP's and 5508 AP's in same location.Mobility is operational between 5508 and 9800 - Guest with Web auth is operating well from 9800 to 5508. Cisco 9800 mobility guide - state...
Resolved! 1832i as autonomous
Hi,Got 5 1832i series LWAP .want to configure as standalone.Firmware is not available for autonomous.So can we configure multiple Access Point as Mobility Express controller in the same network
I have a guesthouse on my property and I'd like it to have WIFI using the same internet connection my main house uses. I had an installer over who installed a coax jack in the guest house and connected a WIFI range extender.Everything seemed to work ...
I have somequestions, I saw access points high up in the middle of the roof, how high can you have access points normally and still get a decent signal ? They were about 25m high I would saysecond, how many users per ap is recommended? I hear about 6...
