cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
333
Views
0
Helpful
1
Replies

Cisco AP1602 UPtime Sleep Mode??

jotto.llc1
Level 1
Level 1

Hello,

I have about 30 Cisco 1600APs running. They have all been up for about 12 weeks since the last shutdown scheduled maintenance shutdown. I purchased 5 Cisco 1602APs to replace some older non Cisco APs, and all 5 of these 1602 won't stay up for more them 3 hours, some are 15min and go down. It seems to me they are under some kind of inactivity policy. If this is so how can I turn it off, I had to shutdown all the radios on these 5 1602s because guest complaining about connections. After shutting down those radios everything is fine running off the older models. 

1 Reply 1

jotto.llc1
Level 1
Level 1

Here is a Log

Cisco IOS Series AP - Event Log

00:06:23 Information Interface Dot11Radio1, Station 3412.9844.3638 Reassociated KEY_MGMT[WPAv2 PSK]
2 00:06:23 Information Interface Dot11Radio0, Deauthenticating Station 3412.9844.3638 Reason: Sending station has left the BSS
3 00:04:00 Information Interface Dot11Radio0, Station 3412.9844.3638 Reassociated KEY_MGMT[WPAv2 PSK]
4 00:04:00 Information Interface Dot11Radio1, Deauthenticating Station 3412.9844.3638 Reason: Sending station has left the BSS
5 00:03:47 Information Interface Dot11Radio1, Station 3412.9844.3638 Associated KEY_MGMT[WPAv2 PSK]
6 00:01:26 Information DFS scan complete on frequency 5280 MHz
7 00:00:27 Notification Line protocol on Interface Dot11Radio1, changed state to up
8 00:00:26 Information Interface Dot11Radio1, changed state to up
9 00:00:26 Notification Line protocol on Interface Dot11Radio1, changed state to down
10 00:00:26 Notification Line protocol on Interface Dot11Radio0, changed state to up
11 00:00:25 Notification Interface Dot11Radio1, changed state to reset
12 00:00:25 Information Interface Dot11Radio1, changed state to down
13 00:00:25 Information Interface Dot11Radio0, changed state to up
14 00:00:25 Notification Line protocol on Interface Dot11Radio0, changed state to down
15 00:00:25 Notification Line protocol on Interface Dot11Radio1, changed state to up
16 00:00:24 Notification Interface Dot11Radio0, changed state to reset
17 00:00:24 Information Interface Dot11Radio0, changed state to down
18 00:00:24 Information Interface Dot11Radio1, changed state to up
19 00:00:24 Warning Interface Dot11Radio1, channel or channel width changed: 40MHz above not allowed on channel
20 00:00:24 Information Interface Dot11Radio1, frequency 5280 selected
21 00:00:24 Information DFS: Scanning frequency 5280 MHz for 60 seconds.
22 00:00:20 Notification Line protocol on Interface Dot11Radio0, changed state to up
23 00:00:19 Information Interface Dot11Radio0, changed state to up
24 00:00:19 Notification Line protocol on Interface Dot11Radio1, changed state to down
25 00:00:19 Notification Line protocol on Interface Dot11Radio0, changed state to down
26 00:00:19 Notification Line protocol on Interface BVI1, changed state to up
27 00:00:18 Warning Full power - INJECTOR_DETECTED_PD inline power source
28 00:00:18 Notification Interface Dot11Radio1, changed state to reset
29 00:00:18 Notification Interface Dot11Radio0, changed state to reset
30 00:00:18 Notification SSH 1.99 has been enabled
31 00:00:18 Notification SNMP agent on host HHWAP-Room is undergoing a cold start
32 00:00:18 Notification System restarted --
33 00:00:18 Notification Configured from memory by console
34 00:00:17 Notification Line protocol on Interface GigabitEthernet0, changed state to up
35 Mar 1 00:00:16.807 Information Interface GigabitEthernet0, changed state to up
36 Mar 1 00:00:14.763 Critical RADIO crypto FIPS self test passed on interface Dot11Radio 1
37 Mar 1 00:00:13.651 Critical RADIO crypto FIPS self test passed on interface Dot11Radio 0
38 Mar 1 00:00:11.871 Critical IOS crypto FIPS self test passed

Review Cisco Networking for a $25 gift card