Cisco AP2802I-E-K9 doesn't broadcast any SSID with PoE Injector AIRI-PWRINJ6

[Onrcan91]

Hi everyone,

I have an AP2802I-E-K9 which will work as standalone.I have totally no problem when i plug into PoE+ switch that's Cisco 2960-X.But the AP doesn't broadcast any ssid when i use a power injector which is AIR-PWRINJ6 with non PoE switch (i tried two different switches hp and cisco ). Even though Cisco states that AIR-PWRINJ6 supports to Cisco 2800 Series APs.I am really in stuck with it. Can you please comment about it dear members ?

 802.3at PoE+, Cisco Universal PoE (Cisco UPOE ®)● 802.3at power injector (AIR-PWRINJ6=)

Thanks in advance.

[marce1000]

 - Issue show logging on the AP  just after boot or scrutinize the complete boot process through a (the) console. Watch for problems concerning radios (enabled or not) related to power.

 M.

[Leo Laohoo]

MESH mode