Cisco c9120axi-e webui problem

[m-ch]

Hello,

I have a Cisco c9120axi-e access point, and I want to configure it, but the SSID is not displaying. I connected it with a router, it got an IP address, but the web interface of the access point is not accessible with its IP address.

Best regards,

[Mark Elsen]

          - It can only be used in standalone mode if it is running embedded wireless controller software (=?)

 M.

[balaji.bandi]

it got an IP address  - what IP it has ? from what device you try to connect to AP ?

check EWC deployment guide :

https://www.cisco.com/c/en/us/products/collateral/wireless/embedded-wireless-controller-catalyst-access-points/white-paper-c11-743398.html

[m-ch]

I recently installed a network access point in my home network to extend my Wi-Fi coverage. I connected this access point to my main router, which also provides an internet connection, and I connected my PC to the same router.

While performing a scan of IP addresses on the network, I found that the access point had obtained the IP address 192.168.1.135. However, when I try to access this address via a web browser, I don't receive any response

[liviu.gheorghe]

Try using https://192.168.1.135

[Mark Elsen]

          -  GUI is only available  if it is running embedded wireless controller software (=?)

M.

[ammahend]

If you are already running embedded wireless controller software, are you able to ping the AP IP or access it via terminal, if yes try different browser, try incognito mode.

[balaji.bandi]

I don't receive any response

connect the console cable and check, also make sure you are running EWC image.

if all good you can start zero day provisioning as mentioned before post :

Day 0 – provisioning using the over-the-air setup wizard