Cisco Catalyst 9800 Mesh Configuration

[Bradley Rousseau]

These are the three configuration guides I have been referring to:

• https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/215100-join-mesh-aps-to-catalyst-9800-wireless.html 
• https://www.cisco.com/c/dam/en/us/td/docs/wireless/controller/9800/17-1/deployment-guide/c9800-mesh-rel-17-1.pdf 
• https://www.cisco.com/c/en/us/support/docs/wireless/embedded-wireless-controller-on-catalyst-9124ax-access-points/221557-configure-point-to-point-mesh-link-with.html 

The problem is that im finding the configuration guides have slightly different GUI menus than I have in my GUI. For example:

• My "AP Join Profile" menu is different than these guides (does not have AP tab)
• I do not have an "ADD" option under the "Site Tag" menu
• I do not have a "Bridge Mode" option or a "Mesh" tab under the "Edit AP" menu

Currently running EWC - 17.12.5

These are really throwing me off, because I cant find any other documentation that shows me how to set this up with the options I currently have available.

Is there any other documentation that would have the options I have in my GUI, or is there another way of going about this?

[Haydn Andrews]

These are for the 9800 WLC not sure if the EWC does something different. On my 17.12.5 I have those options.

You mention EWC what model AP is it running on?
the first 2 links you have listed are more for Mesh with a 9800-xx controller. Here is another one for just the EWC might more align

Keep in mind the AP has to be a 9124 to support mesh with EWC

https://www.cisco.com/c/en/us/td/docs/wireless/controller/ewc/17-6/config-guide/ewc_cg_17_6/mesh_access_points.html#Cisco_Concept.dita_a238aeab-face-4371-a6f2-cca2887b7294 

[Bradley Rousseau]

I have two C9120AXI-B's

[srimal99]

refer to old community page using 9120
https://community.cisco.com/t5/wireless/9120axe-workgroup-bridge-mode-client-mode/td-p/4510732