cisco nexus 7000 swith module and cisco AP 2600

[ngo duyen]

we have network with  nexus 7009 core and a module  ML-148GS-11L 

we are deploying cisco wireless in the netowrk. wlc 2504 and AP 2602I

wlc 2504 connect direct to ML-148GS-11L (trunk)

interface Ethernet5/35

  switchport
  switchport mode trunk
  no shutdown

If I connect AP 2600 through a swith 2960 which trunk with ML-148GS-11L, the AP register with wlc2504 and client can connect to wireless network

If I connect AP 2600 connect direct to  ML-148GS-11L (edge port, access), the AP register with wlc2504 but client cant see any SSID.

interface Ethernet5/37
  switchport
  switchport access vlan 99
  spanning-tree port type edge
  no shutdown

Does the module switch not compartible with AP 2600 ?

Regrads,

[Leo Laohoo]

You will probably not see the SSID because the M1 line card is NON-PoE.

[ngo duyen]

All my ap use power injector. Anh the ap registed to the wlc

[Leo Laohoo]

Ok, if the APs are UP and registered to the WLC:  

1.  Is the SSID broadcasted in both 802.11a and 802.11b radios? 

2.  Do you have "Broadcast SSID" enabled?

3.  Is the AP in the correct AP-Group?

[ngo duyen]

hi Leo,

1. SSID broadcast all radios

2. "Broadcast SSID" enabled

3. All AP in default-group

and client cant get SSID from the AP which connect to M1 line.But at the same time, the client can connect to other APs which connected to nexus through a 2960x switch.

[ngo duyen]

AndThe AP work well if I connect with the M1 line through Fabric 2248TP