cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
434
Views
0
Helpful
5
Replies
Highlighted
Beginner

cisco nexus 7000 swith module and cisco AP 2600

we have network with  nexus 7009 core and a module  ML-148GS-11L 

we are deploying cisco wireless in the netowrk. wlc 2504 and AP 2602I

wlc 2504 connect direct to ML-148GS-11L (trunk)

interface Ethernet5/35

  switchport
  switchport mode trunk
  no shutdown

If I connect AP 2600 through a swith 2960 which trunk with ML-148GS-11L, the AP register with wlc2504 and client can connect to wireless network

If I connect AP 2600 connect direct to  ML-148GS-11L (edge port, access), the AP register with wlc2504 but client cant see any SSID.

interface Ethernet5/37
  switchport
  switchport access vlan 99
  spanning-tree port type edge
  no shutdown

Does the module switch not compartible with AP 2600 ?

Regrads,

 

 

5 REPLIES 5
Highlighted
Hall of Fame Community Legend

You will probably not see the SSID because the M1 line card is NON-PoE.

Highlighted

All my ap use power injector. Anh the ap registed to the wlc
Highlighted
Hall of Fame Community Legend

Ok, if the APs are UP and registered to the WLC:  

 

1.  Is the SSID broadcasted in both 802.11a and 802.11b radios? 

2.  Do you have "Broadcast SSID" enabled?

3.  Is the AP in the correct AP-Group?

Highlighted

hi Leo,

1. SSID broadcast all radios

2. "Broadcast SSID" enabled

3. All AP in default-group

and client cant get SSID from the AP which connect to M1 line.But at the same time, the client can connect to other APs which connected to nexus through a 2960x switch.

Highlighted
Beginner

AndThe AP work well if I connect with the M1 line through Fabric 2248TP

Content for Community-Ad