03-10-2014 11:46 AM - edited 07-05-2021 12:23 AM
Hi ,
how can i schedule 2 or more tasks in CPI for one Wireless Lan Controller.
For example to download *.aes software , reboot and 2 hours later download *.ER.aes software and reboot ?
Thanks
03-11-2014 12:17 AM
Hi,
Check : this is for WCS but in PI it almost similer:
Fot software related schedule task: Configure > Scheduled Configuration Tasks > Download Software Tasks
http://www.cisco.com/c/en/us/td/docs/wireless/wcs/7-0MR1/configuration/guide/WCS70MR1/ctrlcfg.html#wp1098833
Regards
Dont forget to rate helpful posts
03-11-2014 01:27 AM
Hi ,
i want to schedule 2 tasks after each other ( 2 hours in between) for the same Controller.
CPI said "You cannot associate a Controller with more than one task" , is there another way
to do this job
We want to upgrdae our WLC software version and Emergency Image Version in one night.
03-11-2014 06:09 AM
NO You can only schedule a single task for one controller.
Fisrt you can upgarde the software of the WLC and then you can only do the emrgency upgrade.
there is no other way. You must take a downtime for this and you have to do it manually. Its always better to do it manually if you have not so many WLCs.
Regards
Dont forget to rate helpful posts
03-11-2014 06:28 AM
ok Thanks for your time
03-11-2014 01:29 PM
03-12-2014 09:46 PM
You can schedule only single task :
http://www.cisco.com/c/en/us/td/docs/wireless/prime_infrastructure/1-2/configuration/guide/pi_12_cg/ctrlcfg.html#wp1081605
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide