Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
I'm in a situation where I would like to plug another standalone AP into the AUX port on another standalone 2702. No controller is used. I'm wondering if this can be done, or if it will work. I can will have power adapters for both. I'm going to ...
Can someone give me concrete reasons why we should NOT enable broadcast forwarding to resolve the issues as described below? We have roughly 85 - 2504 WLCs all running 8.0.120 code scattered across 85 physical sites. We have an issue that I have fi...
Hi,Is there a way to select with what controller can an AP register ? I have 40APs and 2 controllers and I want to be able to choose with what controllers an AP will register based on MAC Address?Thank you!
Hi there we just upgraded our Cisco WLC 5760 from IOS XE 03.03.03 to IOS XE 03.06.03 and every thing seems to be working fine, except that we get a lot of the following error messages:Sep 24 13:00:10: [CAPWAP] %Error: fast_ipwrite returned 2. Try ipw...
Hi, trying to get an AP to register with the controller, but it aint happening. I was reading an old post:https://supportforums.cisco.com/discussion/12503981/cisco-air-ap3702i-uxk9-flashing-redgreenoff-registered-wlcand it mentions that the AP is un-...
Need a in between solution for APs..need to find out the CISCO AP model that support standalone mode (autonomous mode) for now. AND these AP will convert to lightweight (with WLC) at later time.The current new 3700, 2700 and 1700 seems all use WLC.. ...
hello everyone, we have a problem with the ip mapping on connection of ISE and WLC. this is how is our network:vWLC: 8.1.111.0 IP:172.16.100.14 ; virtual Ise: 1.0.3.876 IP:172.16.100.17Both are on the same virtualization server.The users...
Dear all, We plan to install on the same site these devices :- AIR-CT2504-50-K9 – as primary controller- AIR-CT2504-HA-K9 – as backup controller- Software version 7.6.130 I didn't find documentation on how to make the HA between the devices.The two d...
Hi! I have vWLC running on vmware.2AP 1702i joined, but APs is not broadcasting at allinterfaces is up, no error etc.. tested 8.0.120.0 and 8.1.121.0 release.Broadcast ssid is on, wlan is enabled and ap and wlan in correct ap group. also tested def...
Hi, When I plug in access points they will cause the port to go down on err-disable because of the BPDU Gaurd. 2602s never used to send BPDUs has this changed with the access points or something else in the system. Is there any need for the guard wh...
Dear community,on several sites I observe same problem: clients on access point AIR-AP1242 get disconnected from time to time. One access point was converted to LAP mode, but it did not eliminate the problem.My assumption is a possible influence of o...
Hi All, I have configured DHCP scope on WLC. I am little bit confused, on interface configuration which IP should be configure for Primary/secondary DHCP server. Thank you Gaurav
Instead of me writing a whole post again I found another individual on expert's exchange who is dealing with the exact same issue as us. We just recently purchased a couple new 3650 48PS-S switches and (3) Aironet 2702i's APs. Signal strength in th...
I was planning to install a virtual wireless LAN controller on a physical machine.But I failed to install when i enter the “bash” mode look like a linux user-interface. I wanna know if vwlc has to be installed based on vmware environment?even if I us...
We installed 10 Cisco 3600i AP's, into one of our new buildings. The AP's are connected to a 2960S PoE switch. The 10 ports are configured for auto power inline. The ports show 15.4 watts. For 8 of the AP's, Radio 0 802.11 b/g/n admin status show...
