Cisco RM-1252G-A-K9 can't access web interface

[mistertokr]

I hope I am in the correct forum for this topic?

For some reason I cannot access the web interface in order to configure this device. I have it connected to a router (DHCP). The router assigns an IP Address and I can ping it. If I attempt to go to that IP Address in any web browser. the page cannot be displayed. I've reset it several times. I have 2 of these and same problem. Am I missing something obvious? I sure hope so...

[Moin Ilyas]

To re-enable the web-browser interface, enter this global configuration command on the CLI:

ap(config)# ip http server

Hope that helps.

[mistertokr]

I have no idea how the CLI works or how to connect and/or access it

[Moin Ilyas]

Connecting to the Access Point Locally

If you need to configure the access point locally (without connecting it to a wired LAN), you can connect a PC to its console port by using a DB-9 to RJ-45 serial cable.

Follow these steps to open the CLI by connecting to the access point console port.

---

Step 1 Connect a nine-pin, female DB-9 to RJ-45 serial cable to the RJ-45 console port on the access point and to the COM port on the PC.

Step 2 Set up a terminal emulator on your PC to communicate with the access point. Use the following settings for the terminal emulator connection: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.

---

Assigning an IP Address Using the CLI

When you assign an IP address to the access point using the CLI, you must assign the address to the BVI. Beginning in a privileged EXEC mode, follow these steps to assign an IP address to the access point BVI using the console port:

	Command	Purpose
Step 1	enable	Enter privileged EXEC mode.
Step 2	configure terminal	Enter global configuration mode.
Step 3	Interface bvi1	Enters interface configuration mode for the BVI.
Step 4	ip address address mask	Assigns an IP address and subnet mask address to the BVI.
Step 5	end	Return to privileged EXEC mode.

[Saurav Lodh]

Reload the image using MODE button

refer

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/1250/installation/guide/1250HIG_TD-Book-Wrapper.pdf