07-17-2013 12:14 PM - edited 07-04-2021 12:27 AM
Hi , i would like to use Cisco's 7500 series WLC in my office to control all my branch office's accesspoints ( nearly 500 AP' ).
How many accesspoints will this 7500 WLC supports per single branch office
& what about the data traffic / controll traffic information flow from clinet to WLC.
how much bandwidth required between AP to WLC for remote WAN traffic per AP.
07-17-2013 11:03 PM
Hello,
This may answer some of your questions
7500 deployment guide
http://www.cisco.com/en/US/products/ps11635/products_tech_note09186a0080b7f141.shtml
Sent from Cisco Technical Support iPhone App
07-18-2013 10:29 PM
HEllo,
The Link below might help you out:-
http://www.cisco.com/en/US/products/ps11635/products_tech_note09186a0080b7f141.shtml
07-19-2013 08:42 AM
Havinder,
its the same link that was posted above. maybe you didnt pay attention.
thanks,
07-21-2013 11:54 PM
FlexConnect APs are deployed at the Branch site and managed from the Data Center over a WAN link. It is highly recommended that the minimum bandwidth restriction remains 12.8 kbps per AP with the round trip latency no greater than 300 ms for data deployments and 100 ms for data + voice deployments. The maximum transmission unit (MTU) must be at least 500 bytes.
Deployment Type | WAN Bandwidth (Min) | WAN RTT Latency (Max) | Max APs per Branch | Max Clients per Branch |
---|---|---|---|---|
Data | 64 kbps | 300 ms | 5 | 25 |
Data + Voice | 128 kbps | 100 ms | 5 | 25 |
Monitor | 64 kbps | 2 sec | 5 | N/A |
Data | 640 kbps | 300 ms | 50 | 1000 |
Data + Voice | 1.44 Mbps | 100 ms | 50 | 1000 |
Monitor | 640 kbps | 2 sec | 50 | N/A |
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide