Cisco VMS can support management of router and switches

[noumanqazi]

I want to use Cisco VMS to manage my IPS and firewalls.

A also have two routere and five switches in place can i use the same software to monitor and manage them or I need separate software.

[mchin345]

VMS 2.3 components and the capabilities of each. VMS is packaged in one sub-box with Obtaining Documentation directing you to VMS documentation and the following two CDs:

1.VMS Management and Monitoring Centers Disk 1 of 2Contains these VMS components and associated product documentation:

CiscoWorks Common Services

Auto Update Server

Management Center for Firewalls

Management Center for IPS Sensors1

Monitoring Center for Performance

Monitoring Center for Security

Management Center for VPN Routers

2.VMS Management and Monitoring Centers Disk 2 of 2Contains these VMS components and associated product documentation:

http://www.cisco.com/en/US/products/sw/cscowork/ps2330/products_installation_guide_chapter09186a00803bd364.html#wp1036990

Management Center for Cisco Security Agents

Resource Manager Essentials

Resource Manager Essentials IDU 12

Management Center for IDS Sensors 2.0.12

Monitoring Center for Security 2.0.13

Note You must install IDU 12 included on Disk 2 for RME to work with VMS 2.3 even if you already have RME 3.5 installed on your server.

[noumanqazi]

Dear Mchin345

Thanks for resposne but unfortunately

you answer does not reflects my answer,

I jsut need to know that will i be able to use it r my two router and five swtiches as well.

Nouman Qazi