Wireless

Hi, i got 5 1242 AP's all up and running (with authentication) but all are running a single VLAN. Please advice where i could get a documentation on implementing multiple VLANs. i need somehting that can still use my existing authentication for ssid:...

I have the older 1200 series ap's 1210's and was curious if Cisco was going to provide a 802.11n radio upgrade for them.Thank you in advance for any informtion on this.

Hello,I want to use a 1310 in access-point mode to give access for users in an environment without barrier. What is the maximum distance can i have whith external antenna air-ant24120, more 200 M? With two external antennas can i have more?Thanks.

I have a controller on code 4.2.61.0 that was upgraded to this..I have some of the legacy Nortel waps which I believe are now 1000 series cisco that constantly recycle..when waps are operational I see their code level is at 4.0.217.0 not at 4.2.61.0....

Hi,Can anyone confirm for me what 802.11 standards the 1250 will support with:A single antennaTwo AntennasThree antennas?I gather, from the HW installation guide, that the 1250 will support 802.11B/G/A on a single antenna and N on two or more. Can an...

What port channel id does the controller use or how can I find out? I created the port-channel to the controller and enabled lag mode but the interfaces are not coming up. Any help would be appreciated. Thank you!

In the Aironet 1250 Series FAQ (http://www.cisco.com/en/US/products/ps6973/products_qanda_item0900aecd806b7c82.shtml), the powering options for the Cisco Aironet 1250 Series mentions --"Beginning late 2007, Cisco will enable auto-negotiating, single-...

What's the command to enable ssid's broad cast. All I see is GUI examples in the doc's, but no cli examples.

Which currently available switches are able to provide PoE to a 1250 AP with both the 2.4 GHz and 5.0 GHz radio modules? I know the switch must support at least 18.5 W and that if only one radio module is installed that it is supported by existing 80...

Why can't I place a WISM in an older 6503 ?I would like to know the technical limitations.

HelloI had maked a sight survey whith a 1231 AP, and 2 2,2dc antannas.now is my qustion - is there any problem, to convert to 1242 whith 2 2.2dBi/2.4Ghz,5.0dBi/5GHz DualBand Dipole AntennaIs the wireless range of these produckts the same??and can a 5...

Hi,we are talking here about autonomous AP in latest 12.4 IOS release.I know well how to create a dhcp pool on an AP and distribute addresses to clients when you have a single interface (radio and Ethernet).But what can we do when we want to create m...

Hi, I have an 877w configured in VPN mode to my HQ. All works fine. Now I would like to give this remote site wireless access via this 877w. Is there an example config anywhere as i just want to create an SSID and perhaps WPA-PSK authentication?What ...