cisco vWlc + flexconnect mode central switched don't work

[Alexius85]

Hi all, and sorry for my bad English.

Last week I installed in my data center a new version of vWlc cisco to manage a few ap in my network.

I have installed 8.5.171.0 version of vwlc small capability.

After installation through vmware dc, I configured a trunk port port vlan 255 for mgmt and 1038 for data port , vlan in dc, in firewall and routing and finally it's all reachable.

But for working my ap and wireless network i have discovered that ap worked only in flex connect mode in virtual wlc.

I have tried  many more solutions but they don't work!!

I need a local mode but in flexconnect mode and i have tried this setting:

Create a ssid wi fi network

Setting wpa2  password

setting interface of 1038 vlan group ( 1038 vlan and network for user wi fi 10.38.0.0/16)

setting ap in flex connect mode and no local switching 

setting in vlan1038 ip and ip dhcp

the ssid broadcast but when I acces dont worked!

I tried a setting vlan mapping e wlan mapping but without solution.

The ap is configured in access port of remote switch with vlan 82 but into ap i reachable with routing vlan mgmt and ip vwlc , the ap is joined!!!

and i reachable dhcp ip and the new network for client wi fi 10.38.0.0/16 vlan 1038 stay in the DC.

Please let me know and thanks for your support.

ap are cisco 1851 and 3802 

Regards 

[Alexius85]

ok no problem ammahend let mw know after test in your lab!

Thanks for support!

[ammahend]

I said I will get back but got a little busy, I will try to find sometime this week and look into it. 

[Arshad Safrulla · Accepted solution]

Can you check the vswitch config in your ESXI? Promiscuous mode must be set to accept.

[Alexius85]

Hi Arshad Safrulla, I don’t know because is another team manage vm. 
tomorrow I will feel my colleague and check it.thank you. 
regards 

[Alexius85]

hello Arshad Safrulla GREAT INTUITION !!

my colleague confirmed that the eth interface (vswitch and port group are not configured with promiscuous mode accept)

now they have it configured and now everything works!

colleagues apologized they made me mad! a thousand thanks!!!

Greetings