Cisco Wireless controller 5508 and Packetfence for web authentication
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-20-2022 01:24 AM
I want to enable Web Auth with Cisco Wireless controller 5508 (Sw Version8.5.135.0) for guest users. Packet fence we are using Version 11.2.0.
I have created a guest SSID in CISCO Wireless Controller as GUEST1 and as per the configuration recommended in technical doc trying to configure the same but it is creating some issues.
Here we want to create a captive portal for guests where they will only have to accept the terms and conditions prior to gaining network access, later we want to use it with guests to register endpoints using their email address. PacketFence sends a PIN code to the guest’s email address.
So kindly help me to achieve the same.
detail setup is attached.
- Labels:
-
Catalyst Wireless Controllers
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-20-2022 02:17 AM
- Check this document : https://www.packetfence.org/doc/PacketFence_Network_Devices_Configuration_Guide.html#_wireless_lan_controller_wlc_web_auth
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-20-2022 02:49 AM
I used this doc only for configuration but its not working.
