Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
269
Views
0
Helpful
1
Replies

Cisco Wireless controller 5760 HA priority setting

Go to solution
nh6we
Level 1
Level 1

‎05-07-2015 03:26 PM - edited ‎07-05-2021 03:11 AM

From the CLI what is the command to change the HA priority setting.  I need to change the setting from low to critical.  At the GUI I am not able to change the setting at all.  Is there a command to accomplish this from the CLI?

Thanks

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Prakash Parvathala
Level 4
Level 4

‎05-13-2015 08:26 AM

At the CLI, enable AP Failover Priority...

Use the below commands to find out the Priority.

conf t

ap capwap priority

Please use the below link for the complete guide of HA deployment

http://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/7-5/High_Availability_DG.html

View solution in original post

0 Helpful
1 Reply 1

Go to solution
Prakash Parvathala
Level 4
Level 4

‎05-13-2015 08:26 AM

At the CLI, enable AP Failover Priority...

Use the below commands to find out the Priority.

conf t

ap capwap priority

Please use the below link for the complete guide of HA deployment

http://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/7-5/High_Availability_DG.html

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card