07-09-2015 05:42 AM - edited 07-05-2021 03:32 AM
Hey Guys,
I am having strange issue,
I am using RF device WT41N0,and was working before with PEAP
and at a sudden it stopped working,but if i change PEAP to LEAP its working.
When i tried PEAP its not authenticating on wlc-5508
All config perfect on wlc,few other sites are working with same settings on wt41n0 and on same wlc.
Its strange i done dip reaserch on it and found like below,
AP-AIR-CAP3502E-A-K9 connected on switch c2960s and working good with PEAP and LEAP.
There is other AP same model connected on c3750 not working with PEAP,but working with LEAP.
The PEAP setings on RF wt41n0 were working before and stopped at a sudden and impacted production.
The APs are in H-REAP mode for remote wlc.
so can anyone explain why is this happening.?..i am thinking from last night still no luck.
Thank you
07-13-2015 04:50 PM
Where is the RADIUS server & did you check any logs on that ?
HTH
Rasika
07-15-2015 08:35 AM
There is local EAP authetication configured on wlc,and i am having few of the site are working with PEAP
on same WLC.
Also there are 2 APs are working good with PEAP.
All AP's are in same group on wlc
so the same RF gun is not working PEAP on other APs.(Not authenticating).
can anyone tel me is the AP gets DHCP ip first? or authentication first?
The radius server is at remote location,and in wlc auth order is local,radius,LDAP
also soft ver on wlc:7.0.220.0
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide