10-24-2012 06:09 PM - edited 07-03-2021 10:55 PM
Dear team
At the moment I have a problem with a WLC. This WLC is not booting by the fact it does not have an image. In the past option 5 in the following menu was selected.
Now I received I message when I select option 6. Telling me that if I upgrade from an .aes image I will left the unit inoperable.
============================================================
Boot Loader Menu
============================================================
1. Run primary image (Image not found)
2. Run backup image (Image not found) - Active
3. Change active boot image
4. Clear configuration
5. Format FLASH Drive
6. Manually update images
------------------------------------------------------------
Enter selection:
Thank you in advance
10-24-2012 06:30 PM
I've seen this before.
You need to RMA the appliance.
PS: As a Cisco staff, you can get this appliance RMA-ed INTERNALLY.
12-15-2017 03:12 PM
Hi guys i'm no have any image on my flash after the clear both images though the menu. Is there any way to solve that ? though tftp ? or something like that ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide