Cisco WLC - show port summary

[justin.devos]

If you issue the show port summary command on a Cisco Wireless Lan Controller

show port sum                      

           STP   Admin   Physical   Physical   Link   Link
Pr  Type   Stat   Mode     Mode      Status   Status  Trap     POE    
-- ------- ---- ------- ---------- ---------- ------ ------- ---------
1  Normal  Disa Enable  Auto       Auto       Down   Enable  N/A     
2  Normal  Disa Enable  Auto       Auto       Down   Enable  N/A  

is this output applicable to the Management interface or the network interfaces of the device? cant quite figure it out and cannot get this interface to come up

thank you

[Leo Laohoo]

Management interface is a logical interface (think VLAN).  Ports are physical interface.  Notice the Link Status shows "DOWN".

[Rasika Nayanajith]

What WLC model is this ? 44xx ?

Make sure you connect these port to 1Gbps switchports