CleanAir issue with 4.1(5)

[Marco Noviello]

Hi guy,

I would like report an issue with the CleanAir submenu:

according to the output the AP-058 report a Microwave Oven (see attached image).

But the AP-058 is a old 1242 AP that don't have CleanAir:

AP Summary
Number of APs.................................... 374

Global AP User Name.............................. administrator
Global AP Dot1x User Name........................ Not Configured

AP Name             Slots  AP Model              Ethernet MAC       Location          Country  IP Address       Clients
------------------  -----  --------------------  -----------------  ----------------  -------  ---------------  -------
AP-058               2     AIR-LAP1242AG-E-K9    00:1d:70:97:71:fa        Halle 7 UG  DE       10.10.4.158      0

Regards

Marco

[Philip D'Ath]

Haha that is funny.

It is possible the device has tried to make some kind of educated guess based on the interference on the 2.4 gig band.

[Javier Contreras]

HI Marco

this could be bad indexing of the persistent device information. I would need the sh run, could you send it to the support alias, so I can check on it?

WLCCA can't report PDA information, unless it is explicitly included by controller in the config output

Thanks.

[Tausif Gaddi]

WLCCA can't report PDA information, unless it is explicitly included by controller in the config output