cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
220
Views
0
Helpful
1
Replies

clients on access point AIR-AP1242 get disconnected from time to time

Andrey128
Level 1
Level 1

Dear community,

on several sites I observe same problem: clients on access point AIR-AP1242 get disconnected from time to time. One access point was converted to LAP mode, but it did not eliminate the problem.

My assumption is a possible influence of other signal working in this band.

Any suggestions?

1 Reply 1

Sandeep Choudhary
VIP Alumni
VIP Alumni

Hi,

Paste the whole  conifg of AP if its in Autonomous mode.

Paste the output of Show WLAN <id>  if its in LAP mode.

 

Regards

Review Cisco Networking for a $25 gift card