Closing session on Embedded AP

[Florent TYMEN]

Hello,

I have an silly issue but i'm blocked.

I'm working on a 892W router.

To close the session between the wireless device and the router's console, the command Control-Shift-6 x is required.

The Issue is that this command is not working for me. I'm using a SuperPuTTY connecting tool.

Is there any trick ?

Thanks

Florent

[Stephen Rodriguez]

are you in the router?  if you are do disconnect, it will ask you to disconnect the session that goes to the AP.

ctrl+shift+^ only works if you are still in the session and want/need to go back a level.

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

[Florent TYMEN]

hello,

Thanks for your response.

I'm in the AP (in the session).

ctrl+shift+^ don't works

I need to specify that i'm using a AS2511-RJ to connect to the console port.

[Leo Laohoo]

To exit out of the imbedded AP it's Ctrl+Shift+6 and then X.

This pushes you out and into the router.  To disconnect the console session from the router to the AP, then enter the router command "disco" and press the enter key TWICE.

[Florent TYMEN]

Hello,

As said above, "Ctrl+Shift+6 and then X" command is not working for me.

However, i found that when i log on console through a AS, without AS, or throught a telnet session, it's not the same behavior.

Finally with a telnet session the key "Ctrl+Alt+6 and then X" is working.

We can close the topic.

Maybe that will help someone.

Thanks. Cheers !

[Scott Fella]

Must be an issue with what you are using. I use SecureCRT and I am able to exit out of my embedded AP when consoled, ssh, or using telnet.

Sent from Cisco Technical Support iPhone App

[Leo Laohoo]

I use SecureCRT and I am able to exit out of my embedded AP when consoled, ssh, or using telnet.

Same here.  I use SecureCRT.

[Florent TYMEN]

So, after more investigations, i found what's wrong.

In my config for line vty, there was a "escape-character BREAK" command ...

After deleting, it's work fine

Thanks a lot for spending time for me.

Florent

[ranjit123]

hello All

"Ctrl+Shift+6 and then X worked for me...

[wsladekjr]

If using minicom, send a break command via the minicom help menu as this keyboard sequence does not work.