05-03-2014 04:13 PM - edited 07-05-2021 12:46 AM
HI,
I have download MSE software image using Prime, and I show, that I need to run the upgrade via MSE CLI, but I don´t understand the upgrade procedure from the Release Note document, do you know which commands I need to run?
thanks
Solved! Go to Solution.
05-04-2014 12:07 AM
Hi
Please refer this & see if that helps. It describe both WCS/Prime & CLI options for MSE software upgrade
HTH
Rasika
**** Pls rate all useful responses. Each time you rate a response Cisco will donate $1 to Kiva ****
05-04-2014 12:07 AM
Hi
Please refer this & see if that helps. It describe both WCS/Prime & CLI options for MSE software upgrade
HTH
Rasika
**** Pls rate all useful responses. Each time you rate a response Cisco will donate $1 to Kiva ****
05-05-2014 12:42 PM
I have run the command ./CISCO-MSE-L-K9-7-6-120-0-64bit without stopping the service and software was reistalled successfully. Now the problem is that Prime don´t see MSE reachable. I made an MSE backup and I was looking for the process to restore MSE form that file, but I have been able to find the process. does any one know how to restore MSE?
thanks
05-08-2014 11:26 AM
Hi,
After delete old MSE form Prime and run /opt/mse/setup/setup.sh command on MSE, set the NCS user and password to default, I could add again MSE and restore it uploading the backup file to Prime disk:/defaultRepo directory and use the manteinance and restore option from Prime for MSE
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide