cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5154
Views
0
Helpful
1
Replies

Comparison between TPCv1 and TPCv2

Manish Mathur
Level 1
Level 1

Hi Experts,

Just after a site survey and fresh Wireless installation , I see that all the APs are transmitting with full power. Both radios. AP model is 3702.

During our investigation , someone suggested that this is due to the fact that we are using TPCv1 (coverage optimal mode). WE should switch to TPCv2 (interference optimal mode) to avoid this situation. However, I am not convinced with this theory. Can someone shed some light on the differences between these 2 modes of TPC and when to use which one ?

Thanks in advance,

Manish

1 Reply 1

Rasika Nayanajith
VIP Alumni
VIP Alumni

TPCv1 is the recommended setting.

See below link for more understanding of these two methods

http://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-2/b_RRM_White_Paper/b_RRM_White_Paper_chapter_0101.html

HTH

Rasika

*** pls rate all useful responses ***

Review Cisco Networking for a $25 gift card