Config. Aironet 1100 as bridges

[mikeself01]

I have Aironet 1100 series AP's I have a span of about 1000 feet I need to put network connectivity across. I have yagi antenna's to connect to the 1100's. I need to know how to configure the 1100's as a bridge. Can anyone point me in that direction or point me to a configuration guide??

[gpulos]

this should be relatively straight forward.

there are a few steps that are required but the quick steps are as follows:

1) configure the radio settings

2) configure the SSID/VLAN settings

3) configure cipher/WEP

4) configure authentication (if required)

5) configure your antenna

6) connect your devices and test

please see the following link for the AP Configuration Guide, IOS 12.2(15)JA: (covers AP 350, 1100, 1200)

http://www.cisco.com/en/US/products/hw/wireless/ps4570/products_configuration_guide_book09186a00801ea410.html

if you have not done any administration on this device or it is new, start with the 'configuring the access point for the first time' section.

[mikeself01]

Thank youfor your reply!

[mikeself01]

Do I need to setup one AP as a Root AP and the other AP as a Workgroup Bridge?