Configuration Cisco AP 2600(AIR-CAP2602I-E-K9) controller 2500

[sajjalokesh.ccie1]

Need some good configuration guide for AP 2600 and the wireless controller 2500.

any suggestions will be good

[Prakash Parvathala · Accepted solution]

Here is a guide you should read also.  This talks about how an AP registers to a WLC:

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a00806c9e51.shtml

Here are the docs for you to configure the basic switch port config for AP's i.e 2600s and wlc.

Wlc port should be configured as trunk.

AP port has to be access.

CAP2600 series requires a wlc software of minimum 7.2.110.0 (Make sure you have this or above release)

To upgrade if you need to follow this.

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00805f381f.shtml

1. http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080665cdf.shtml (SW port configs)

2. http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a00806c9e51.shtml

(ANother very importand thing, discovery mechanism, choose appropriately)

If you choose dhcp option 43, it uses TLV format. Type is always f1, length is 4*(no.of wlc for which you want to provide discovery for , in ur case one) Value = Hex conversion of the management ip address of wlc.

A video for the process,

http://www.youtube.com/watch?v=oOh_Iv1CHxQ.

[Sandeep Choudhary]

HI Sajjal,

Check this doc:

http://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lan-controllers/69719-wlc-lwap-config.html

Regards

Don't forget to rate helpful posts

[Moin Ilyas]

Cisco Wireless LAN Controller Configuration Best Practices