Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

AP2600 can not join to virtual 2500 WLC

Hi, I installed virtual 2500 WLC on ESX server. Customer has 3 AP's but one of them can not join to WLC altough has same switch configuration with other them. When I connecting with console cable to not joined AP below outputs shown. *Aug 15 18:01:35...

Cisco WISM2 HA problem

hi alli have two cisco WISM2 in two 6500 configured as VSSafter I configured the HA from GUI, the two controllers rebooted together and i connect console to the primary one when it reach to starting the redundancyit fail and appear to me  Dropping AR...

5508 reboot lose License

I have WLC 5508(version7.4) and 50 AP-Licenses. When reboot the WLC, the AP-License will be lose.I have to import the license file with tftp again(although the WLC will remind the file already exists).

Di Zhang by Beginner
  • 420 Views
  • 4 replies
  • 0 Helpful votes

Guest Network

Helloon a wlc 4400 series guest ssid configured, lately noticed Guest SSID is broadcasted but takes long to connect or at times dont connect.Other SSID configured with WPA2 works ok.  Checked the followingIssue occurs on Smartphones and Laptops DHCP ...

Access Provisioning and N+1

I have setup 3 new controllers in and N+1 configuration. Two are active and one is an HA-SKU backup controller which either of the primary's can failover to. The setup looks good and has been verified. Now it is time to provision access points. I hav...

Matthew by Beginner
  • 270 Views
  • 6 replies
  • 0 Helpful votes

Voice over Wireless Outdoors?

Has anyone deployed outdoor VoWiFi? I am charged with studying the feasability of an outdoor wireless voice solution for a large outdoor courtyard between several buildings. The layout of the campus would require a mesh network. I would most likely u...

Resolved! AIR-CAP3702E-A-K9and WLC5508

Hello,I have a 5508 WLC with the 7.6.120.0 Software Version.  I connect some new, out-of-the-box AIR-CAP3702E-A-K9 AP's and they show:CleanAir Admin Status = EnableCleanAir Oper Status = DOWNWhen I go to the "Wireless" Tab, then to "Radios" on the me...

HA client SSO - traffic interruption

 Hello ,kindly i enabled HA with client SSO on a pair of WISMs installed in 6500 VSS mode . the configuration is ok .when i am going to test client SSO . i sent a stream of ICMP packets from a wireless client then i did a switch-over for the controll...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers