Configuration of LOCAL mode in Cisco9800 vWLC

[neph10]

Hi Cisco Community. We just want to know what configuration we needed in order to configure local mode(not flexconnect) in cisco 9800 vWLC same as in cisco 5500 series. Hoping for your kind response. Thanks in advance.

[Mark Elsen]

 - You need to look into the  AP Join profile settings . where it is configured if the AP is in Local or Flexconnect mode.

 M.

[neph10]

This is the one you are talking about right? We tried enabling the local site but unsuccessful. Clients were not getting ip address. Im not sure what settings we still need to change

[Mark Elsen]

 - You may already have the current controller configuration reviewed with (CLI) show tech wireless : have the output analyzed by https://cway.cisco.com/tools/WirelessAnalyzer/

  Look for hints and advisories , note -> use command as mentioned in green , do not use traditional show tech-support , for Wireless Analyzer.

 M.