CONFIGURING 2720I WIRELESS ACCESSPOINT

[isaaco001]

Dear Community,

I am trying to configure a 2720i Acess point.when i configured 1130AG.I configured the e0 interface and was able to reached the browser gui for the rest of the configuration.Does tehe 2720i have a browser for configuration?In the attached file,you will see that i have configured the g0 interface.The problem is i cant ping that interface at all.I have done a show flash: and boot up process to show important details that i might be missing.

To add,the ap come in lwapp mode and i found the k9w7 in flash so i changed it to standalone through

Boot:flash/standalone image

Thank you all!

[Sandeep Choudhary · Accepted solution]

how you configured the switch port where it is connected ?

Also configure the default-gateway on AP.

Regards

Dont forget to rate helpful posts

[isaaco001]

Hi Sandeep,

Thanks for you answer. I have configured the default-gateway  now as you can see in the show run in the file attached.192.168.1.1 is the default gateway. What should be configured on the switch?I am still troubleshooting.

Regards,

Isaac

[Sandeep Choudhary]

you must allow the VLAN(X) on switch port.

[isaaco001]

Hi Sandeep,

test

[isaaco001]

test

[isaaco001]

Sandeep,

It finally worked!I just configured the bvi interface with and ip and removed the ip on g0.I have to use a complete new set of patch cords,because i thought i could be layer 1 issue.I can now access the gui.

Attached is the attached configs for sho run(working).

Thanks for amazing support.