Confirmation the configuration was saved - CLI

[JASON SIMMONS]

I'm trying to build a configuration change template in Orion NCM.  The script should automatically enter the "y" after the save config command is given.  When I run it I don't get the configuration saved message back like If I did it manually.  I searched through the log files and didn't find any reference to the configuration was saved.

So is there a way to confirm that the configuration was saved?

[Scott Fella]

Jason,

I would make sure your script waits for the prompt before issuing the 'y'. That is how my scripts run or else it does fail. 

-Scott