Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Hi!I have the next trouble. I have CUCM 7.1.(5), WLC 5508 and bunch of 7921s, 7911sAnd I have a lot of disconnects. often a conversation with 7921 (every one of a bunch) is lost.I have the last firmware on 5508 - 7.0.220.0. I have H-REAPAnd I loaded ...
Hi All,I have WLC and AP with mode Flexconnect with followin VLAN mappings:At layer 3 switch I have two VLANs:Vlan427 (used for wirlles scanner ) Vlan499 (native vlan)At layer 2 switch wich is connected to L3 the port where AP is ...
I have a rather dense 5GHz AP deployment, however we're deploying dual band APs. I can turn off half or more of the 2.4 GHz radios to keep the co-channel Interference/contention down, but would rather put the 2.4 GHz radio in monitor mode. Has anyo...
Can I use ISE to authenticate guest SSID,(only allowing Internet connection, while denying all production network access)?If the answer is yes, please let me know how to do it.Thanks,
hello,I tried to configure an AP which is in light mode to have multiple SSID as I do with autonomous AP but I couldn't, is it possible for an AP in light mode to have multiple SSID? if so, how can I do that?Thank you in advance for your help.
Upgrade my Cisco WLC 2504 to 80.100 and my AIR-LAP1141N-A-K9 radio wont enable. They Show Admin Status Enable but Operational Status Down. Any Ideas???
Dear All, I need some help with configuring a brand new CT-2504-K9 V03 which is supposed to be shipped with IOS 7.6.120.0 which has express setup feature. AS per the quick start guide found in the box, I set to plug my laptop to port on the WLC and w...
I am looking to upgrade 2 of our current 1310 wireless bridges with the 1532E model, and using the 5GHZ 14dBi antenna-AIR-ANT5114P2M-N.We are looking to achieve increased throughput and a higher data rate than the previous 54MB bridge. The approxima...
Hi Support, Can I get the procedure to upgrade the firmware of leightweight AP 2702i firmware to its latest version of leightweight firmware.All I am getting is the Leightweight to Autonomous procedure which I dont require. Regards,Ninad Thakare
Dears, Kindly i see MSE down on the prime Also i found that the service on MSE is not running and giving the below errors: [root@IEOC-MSE ~]# getserverinfoHealth Monitor is runningStarting MSE Platform, Waiting to check the status.Starting MSE Platfo...
Can i managed Access point 3110 and 1602 using 2504 controller with software 7.4.x?
Hi Everybody, I try connect two access point AIR-CAP1602E with WCM( Controller Wifi) on switch WS-C3650-48FPS.My AP doesn't connect with my controller and i have a error in software log (see Attachment)My config wlan on switch is :wlan ASPDTBSP 2 ASP...
I need a wireless AP list compatible with AIR-CT2504-15-K9! Thanks!
I tried configuring snmp string on aironet 3602E. It gets configured but movement i restart the AP, configurations are not saved. I tried using write memory command but no use.Kindly assist
Hi everyone,has anybody experienced the following error: * Start Cisco Crash Handler Serv *************************************************************Sys Name: alma-cc-wifi-suyu-02Model: AIR-CT5508-K9Version: 7.5.102....
