02-11-2019 05:33 AM - edited 07-05-2021 09:49 AM
Hello
i have a controlleur with IOS 8.2.170
and AP 1815i
so what ios that i can downlod in controlleur that allow work to 1815i OR what IOS in 1815i that allow work with controlleur 8.2.170 ????,,
please , i need a help about this ^problem !!
thanks in advance
Solved! Go to Solution.
02-11-2019 05:57 AM
you need 8.3.112.0 or higher version on WLC .
Regards
Dont forget to rate helpful posts
02-11-2019 05:43 AM - edited 02-11-2019 05:47 AM
Check the compatibility matrix here:
**Edit** Can't even read my own link. As Sandeep said in the other post you put up, you need code 8.3.112.0 minimum to get it to work.
02-11-2019 05:54 AM
vesrion ap 1815i
AP28AC.9E89.3E10 uptime is 0 days, 0 hours, 55 minutes
Last reload time : Mon Feb 11 11:35:09 UTC 2019
Last reload reason : unknown
cisco AIR-AP1815I-I-K9 ARMv7 Processor rev 5 (v7l) with 1015956/821884K bytes of memory.
Processor board ID FGL2209B3S8
AP Running Image : 8.3.111.0
Primary Boot Image : 8.3.111.0
Backup Boot Image : 8.3.111.0
1 Gigabit Ethernet interfaces
2 802.11 Radios
Radio FW version : 8edf74e05d634a962e683454e8fc1be2
NSS FW version : not available
--More-- [*02/11/2019 14:48:57.4599]
[*02/11/2019 14:48:57.4599] CAPWAP State: Discovery
[*02/11/2019 14:48:57.4699] Discovery Request sent to 255.255.255.255, discovery type UNKNOWN(0)
[*02/11/2019 14:48:57.4699] Discovery Response from 1.1.1.111
[*02/11/2019 14:48:58.0000]
[*02/11/2019 14:48:58.0000] This AP model is supported by controller version newer than 8.3.15.100!
[*02/11/2019 14:48:58.0000]
[*02/11/2019 14:48:58.0000] Discovery response from MWAR 'Cisco_c8:e9:71'running version 8.2.170.0 is rejected.
[*02/11/2019 14:48:58.0000] Failed to decode discovery response.
[*02/11/2019 14:48:58.0000] CAPWAP SM handler: Failed to process message type 2 state 2.
[*02/11/2019 14:48:58.0000] Failed to handle capwap control message from controller - status 4
[*02/11/2019 14:48:58.0000] Failed to process unencrypted capwap packet 0x21a7000 from 1.1.1.111
[*02/11/2019 14:48:58.0000] Failed to send capwap message 0 to the state machine. Packet already freed.
[*02/11/2019 14:48:58.0000] IPv4 wtpProcessPacketFromSocket returned 4
Base ethernet MAC Address : 28:AC:9E:89:3E:10
Part Number : 0-0000-00
PCA Assembly Number : 074-105850-02
PCA Revision Number : 0
PCB Serial Number : FOC22063ABK
Top Assembly Part Number : 074-105850-02
Top Assembly Serial Number : FGL2209B3S8
Top Revision Number : A0
Product/Model Number : AIR-AP1815I-I-K9
//////////////////////////////////////////
version controlleur :
~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2019.02.11 13:54:14 =~=~=~=~=~=~=~=~=~=~=~=
show tech-support
---------------Show boot---------------
Primary Boot Image............................... 8.2.170.0 (active)
Backup Boot Image................................ 8.2.170.0
---------------show time---------------
Time............................................. Mon Feb 11 13:53:38 2019
Timezone delta................................... 0:0
Timezone location................................
---------------Show Inventory---------------
System Inventory
Burned-in MAC Address............................ 00:0C:29:C8:E9:71
Maximum number of APs supported.................. 200
---------------Show udi---------------
NAME: "Chassis" , DESCR: "Cisco Wireless Controller"
PID: AIR-CTVM-K9, VID: V01, SN: 97OOPOS3PDR
---------------Show sysinfo---------------
System Information
Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 8.2.170.0
RTOS Version..................................... 8.2.170.0
Bootloader Version............................... 8.3.15.96
Emergency Image Version.......................... 8.2.170.0
Build Type....................................... DATA + WPS
System Name...................................... Cisco_c8:e9:71
System Location..................................
System Contact...................................
System ObjectID.................................. 1.3.6.1.4.1.9.1.1631
IP Address....................................... 1.1.1.111
IPv6 Address..................................... ::
System Up Time................................... 0 days 0 hrs 12 mins 5 secs
System Timezone Location.........................
System Stats Realtime Interval................... 5
System Stats Normal Interval..................... 180
--More-- or (q)uit
Configured Country............................... TN - Tunisia
State of 802.11b Network......................... Enabled
State of 802.11a Network......................... Enabled
Number of WLANs.................................. 1
Number of Active Clients......................... 0
Burned-in MAC Address............................ 00:0C:29:C8:E9:71
Maximum number of APs supported.................. 200
System Nas-Id....................................
WLC MIC Certificate Types........................ SHA1
Licensing Type................................... RTU
vWLC config...................................... Small
---------------Show advanced backup-controller---------------
Backup Controller Configuration
AP primary Backup Controller ....................
AP secondary Backup Controller ..................
---------------Redundancy Information---------------
--More-- or (q)uit
Redundancy Information
Redundancy Mode ................................. SSO DISABLED
Local State...................................... ACTIVE
Peer State....................................... N/A
Unit............................................. Primary
Unit ID.......................................... 00:0C:29:C8:E9:71
Redunadancy State................................ N/A
Mobility MAC..................................... 00:0C:29:C8:E9:71
Redundancy Management IP Address................. 0.0.0.0
Peer Redundancy Management IP Address............ 0.0.0.0
Redundancy Port IP Address....................... 0.0.0.0
Peer Redundancy Port IP Address.................. 169.254.0.0
//////////////////////////////////////
So what ios can upgrad controller that allow AP work witk controler or virs vers ????,
what solution for upgrade IOS in AP or controlleur?????????,
thanks in advance
02-11-2019 05:57 AM
you need 8.3.112.0 or higher version on WLC .
Regards
Dont forget to rate helpful posts
02-11-2019 06:14 AM
Ok , i ask if this version 8.3.112 can upgrad in WLC virtual ???????,
thanks in advance
02-11-2019 05:46 AM
02-11-2019 09:35 PM
Please refer to CSCuw56127 and change the controller country settings to either Egypt or Israel.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide