08-16-2010 08:45 AM - edited 07-03-2021 07:04 PM
Hello,
Anyone knows how to copy the SSC from AP Policy page from one controller to another? I have accumulated 134 access points with SSC and I need to copy them to a new controller. Is there an easy way (one time) of doing this?
Solved! Go to Solution.
08-16-2010 09:50 AM
Depending on the version you are running capture the output of either "show running-config" or "show run-config commands" from the controller. In the output you'll see " auth-list add ssc
Go to the new controller and type "config" and hit enter. You're prompt will change to "(Cisco Controller) config>"
Paste in the auth-list entries you copied from the old controller's config.
08-16-2010 09:50 AM
Depending on the version you are running capture the output of either "show running-config" or "show run-config commands" from the controller. In the output you'll see " auth-list add ssc
Go to the new controller and type "config" and hit enter. You're prompt will change to "(Cisco Controller) config>"
Paste in the auth-list entries you copied from the old controller's config.
08-16-2010 12:12 PM
Thanks! I copied the output of show auth-list, pasted in notepad and added auth-list add ssc
It requires a little time to edit but at least I didn't have to do each entry one by one.
02-21-2011 03:03 PM
Little hint ... if you do the show run-config [no-ap], will save yourself the trouble of looking through a ton of APs...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide