07-20-2017 01:19 AM - edited 07-05-2021 07:22 AM
Hi,
I have a question about how to set up different Vlan on one AP 1832I.
I only have an AP 1832I, and I connected it to my C2960 switch, and I'd like to set up two Vlans which one for office and the other one for guest. My question is how to make it working?
Solved! Go to Solution.
07-20-2017 03:59 AM
Hi,
Here is the sample Configuration of switch-port:
interface Gig0/20
switchport mode trunk
switchport trunk native vlan 3
switchport trunk allowed vlan add 3,4,5
info: Vlan 3 is the management vlan for AP.
Vlan4- Office user
Vlan 5- Guest
Regards
Dont forget to rate helpful posts
07-20-2017 01:31 AM
you will need to set up the port to which you connect the AP as a trunk, then define both VLANs on your AP.
PLease rate if helpful
07-20-2017 03:01 AM
Thanks a lot to your reply. I am not sure where is the problem. I've already set up the port which connected the AP as a trunk. But the AP seems not working after that.
07-20-2017 03:59 AM
Hi,
Here is the sample Configuration of switch-port:
interface Gig0/20
switchport mode trunk
switchport trunk native vlan 3
switchport trunk allowed vlan add 3,4,5
info: Vlan 3 is the management vlan for AP.
Vlan4- Office user
Vlan 5- Guest
Regards
Dont forget to rate helpful posts
07-20-2017 09:08 PM
Great. Thanks a lot. The problem has been solved.
07-20-2017 03:45 PM
send the config of the AP please.
please rate if helpful
07-20-2017 09:08 PM
The problem has been solved. Thanks a lot.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide