CWA on EWC1915 using ISE

[andres-cobo]

Hi Community, I'm trying to configure CWA using ISE in a EWC1915 but I had many issues to configure the redirection. Is it possible to configure it properly on that model? most of the documentation I found is for the WLC9800 and some features seems to not be available on the GUI. I must mention too that we are using EntraID as external IdP to use MFA before accessing to the network.

Thanks.

[Rich R]

Did you maybe mean 9105 AP @andres-cobo ? (There is no EWC1915 AP)

Most of the 9800 features should work on EWC but the major difference which you need to remember is that EWC only supports Flexconnect Local switching.

The full matrix of features which are supported can be found at https://www.cisco.com/c/en/us/td/docs/wireless/access_point/feature-matrix/ap-feature-matrix.html

Have you checked your EWC config using the Config Analyser (link below) - that will identify many common config mistakes and best practice guidelines?

Did you follow the guide at https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/213920-central-web-authentication-cwa-on-cata.html ?

Is your software version up to date?  Refer to TAC recommended link below.