cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
443
Views
0
Helpful
1
Replies

Data not showing in the security risk interferers Report in Cisco Prime Infrastructure after the Upgrade of WLC

BhaskarDS
Beginner
Beginner

Issue: After the upgrade of the WLC to 8.10.112.0 version, the report is not showing any data in the Cisco Prime infrastructure Under Report Launch Pad -> Clean Air -> Security Risk Interferers.

 

Analysis done:

-- Installed the latest device pack and the maintenance release in the Prime.

-- Removed and re-added the WLC in the prime.

-- Restarted the services. The WLC whenever downgraded to earlier version 8.3, the report will show.

 

Is that feature doesn't support in the 8.8 and later versions of WLC ? Is cause whenever it is downgraded to lower version, the report will show. Is there any bug related to that ?

1 Reply 1

marce1000
VIP
VIP

 

 - Perhaps the procedure to get these data has changed :

   https://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/3-7/user/guide/bk_CiscoPrimeInfrastructure_3_7_0_User_Guide/bk_CiscoPrimeInfrastructure_3_7_0_User_Guide_chapter_01100.html#task_1156759

 M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: