09-30-2005 06:06 AM - edited 07-04-2021 11:10 AM
Here is my scenario. I have a Cisco Cat3550 switch. Three of the ports are set to access mode for vlan 2. My WLSE Express is plugged into one, my 1210 AP is plugged into another, and my laptop is plugged into the third. The switch is my DHCP server.
When the AP or my laptop boot up, they receive IP addresses from the switch correctly. The AP receives its config file from WLSE and is online.
The problem is that when I connect to the wifi, which is assigned to vlan 2, I don't receive an IP address via DHCP. When I'm plugged into the switch I do.
I've attached my config file for the AP. Can anyone tell me what I am doing wrong here?
09-30-2005 07:50 AM
What version of IOS is on this AP?
09-30-2005 07:51 AM
Also what is the native vlan on the switch?
09-30-2005 09:15 AM
I'll have to check on the IOS, but the native vlan is 1.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide