Wireless

So I have an AP configured to use a radius server for eap-tls the CA and Radius server are MS CA and MS IAS clients are XPpro. Everything is working fine. So where my question is the cracking of a WEP(128bit encryption). Could someone be in the area ...

My building is about 70 years old and made of block and concrete. Like a hospital or a school.We have two hallways that run parrallel and are about 100 feet long, and are about 40 ft apart with a corridor that connects them to for basically an H. Und...

Hi All,We use cisco 1130AG AP's in our enviroment. (both autonomous configs and LWAPP). For wireless survey's and simulated designs, I use fluke's "InterpretAir". I have noticed a couple annoying things. the options for wall structures are very limit...

Is a dedicated controller in DMZ really required for Guest Access?I haven't found a wealth of justification for a dedicated controller in DMZ for a location which has only 3 APs. What is the risk level of directly attaching a port on a 4400 controlle...

I have a WLAN controller at HQ and want to put APs at my branch offices, but connected and managed by my controller at HQ. I know that if the WAN goes down, I will lose wireless, etc.my question is:Is there anything I should watch out for with this t...

hi, i hv a wireless IP phone,AP, 2960 switch1 and another 2960 switch2. My question is, if i configured voice vlans on th access ports on th switch1 (for voice and data), this switch1 is connected to the AP and the IP phone gets connected to the AP s...

When i try to configure WLSE thru http access. It says WLSE is currently loading information. You will automatically be logged on when loading is complete and gets stuck there not proceeding what could be the problem. I tried to update the software t...

We are trying to get wireless working using Active Directory. It works using the CiscoSecure local DB for users but it won't when it's pointed to AD. We have the AD set up best to out knowledge but still get an "Internal Error" in the ACS logs. Any i...

As stated above i have a 4400 wireless controller and a air-lap1242AG-A-k9 access point. I have the wireless controller all setup and it seems the LAP ap can not find the wireless controller. i do a Lwapp debug and it scrolls Could not discover any W...

I just installed WCS 4.1 and have a test rouge AP. I've been doing some testing with containment, but somehow deleted the rouge AP alert in WCS. I see the rouge AP in WLC, but it's not showing up in WCS. How do I get the rouge AP to reappear in WCS?

cisco 1100 software was be disabled,and hardware down. But i can telnet 10.0.0.1, How to sovle it? To enable the dot11radio.

All, I'm in Iraq and I was using the "B" side on at 3 miles away with a solid dish "AIR-ANT3338" and was getting 2meg down on by bandwidth and now I'm lucky to get 400K. I have one root hub and 4 non root hubs linking to it with no more than 6 users ...

hallo i have version 3.2.78 on my wlc 4402 and i want to configure it for EAP-TLS. it should be secured by 802.1x and wpa2 but i dont know how to do it properly over the webinterface. every suggestion is appreciated.

Hello,recently I've installed a Cisco WCS server.In the MAPS section I have added a map (outdoor area) and I have dragged the two access point in the map(1 RAP and one MAP) to see the heat map of the signal.The problem is that for the first 2 days it...