02-12-2024 12:18 AM
Hi
We have setup WLC as showing in drawing below;
DHCP (10.133.139.0/24) on wlc, and this is working fine with DMLZ Area.
and we have issue when we want to add new segment in GBC area with segment 10.133.136.0/24. client in GBC tenant AP still get same ip addres with DMLZ area. 10.133.139.0/24 from DHCP in WLC (even we add new pool in WLC DHCP for 10.133.136.0/24 ). do you have any advise to solve this issue ? where to put DHCP ? may be other solution.
currently we have 3 network segment (10.133.139.0, 10.133.138.0 and 10.133.136.0 ) with same vlan210. we cannot change this VLAN configuration becuase client only give us 1 vlan for 3 segment above.
Regards
DY
02-12-2024 04:00 AM
Since all APs managed by same WLC and that WLC SVI for vlan 210 is in 10.133.139.0/24 range you always get IP address from same range. Without creating 3 SVI (vlans on WLC) I do no think you can solve it easily.
HTH
Rasika
*** Pls rate all useful responses ***
02-12-2024 05:55 PM
Hi Rasika,
Thank you for reply,
if we move DHCP server from WLC to windows server and put ip helper address in Client switch (10.133.136.252 and 139.252 ) and disable DHCP centeral . is it possible to solve it ? or please advise me if you have any?
it's really appreciated your help .
Regards
DY
02-13-2024 04:08 AM
I believe traffic is centrally switched. That is those APs are in local mode and traffic is tunnel to that WLC.
In that scenario, you have to have 3 dynamic interfaces on your WLC in order to assign users into 3 different subnets
HTH
Rasika
*** Pls rate all useful responses ***
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide