06-17-2011 10:05 PM - edited 07-03-2021 08:19 PM
HI,
i have configured autonomous AP with IP 172.16.10.127 and brought it in network
it is directly connected to core switch. when i do sh cdp neighbor gig6/8 detail, it is showing IP address of AP as 172.16.10.68.
help on this..
06-17-2011 10:08 PM
ok!! get the access to the AP and assign the IP address again manually..
en
conf t
int bvi 1
ip addr
no shut
end
See if we are still able to get other IP addr..
Regards
Surendra
06-17-2011 10:26 PM
hi surendra,
when i got console and do sh ip int br, it showed -
Interface IP-Address OK? Method Status Prot
ocol
BVI1 172.16.10.127 YES NVRAM up up
Dot11Radio0 unassigned YES NVRAM up up
Dot11Radio1 unassigned YES NVRAM administratively down down
FastEthernet0 172.16.10.68 YES NVRAM up up
fastethernet was different.. how it was something different?
i configured this AP from web interface.
thanx for the help
06-17-2011 10:35 PM
Your management IP address should be the BV1 and not the FastEthernet0. You don't need to assign an IP address to the FE.
06-17-2011 10:40 PM
Hi,
As leo stated. the IOS AP should be assigned the IP on BVI interface not any where else!!
Regards
Surendra
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide