12-19-2013 09:16 AM - edited 07-04-2021 01:27 AM
12-19-2013 09:48 AM
Try this & see
AAP1(config)#led display ?
dim Turn LED display dim.
off Turn LED display off.
HTH
Rasika
**** Pls rate all useful responses *****
12-19-2013 09:48 AM
Try this & see
AAP1(config)#led display ?
dim Turn LED display dim.
off Turn LED display off.
HTH
Rasika
**** Pls rate all useful responses *****
12-23-2013 11:00 AM
Thanks for your request
This command apply for Cisco Access-Point 2602 but Do you know the command for Cisco Access-Point 3602e.
I tried apply this command and not work
Regards.
12-23-2013 01:09 PM
Does this 3602e is in Autonomous mode as well or is it managed by a WLC ?
If it is manged by WLC you have to do this via WLC
(WLC) >config ap led-state disable
If it is autonomous mode, let me know the code version to check & see
HTH
Rasika
**** Pls rate all useful responses ****
12-23-2013 02:52 PM
All access-point are 2602e but had different IOS version. The command LED DISPLAY OFF is correct, but depend of IOS version.
Regards.
07-09-2021 10:44 PM
Hi, could you indicate the command to turn off the led on Cisco AIR-SAP2602I-A-K9 IOS Software, C3600 Software (AP3G2-K9W7-M), Version 15.2(2)JA, RELEASE SOFTWARE (fc1)? Thanks in advance.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: