11-23-2011 09:19 PM - edited 07-03-2021 09:07 PM
Hi guys
I am using a 1310 AP (bridge) with power injectors.
I have tried to power off the injectors, but the dot11radio interface is not showing up. Its showing status reset and protocol down,
Please help!Urgent
Regards,
Rachna
11-24-2011 03:33 AM
Is this a new install? If so, did you configure the SSID and authentication method for that radio?
http://www.cisco.com/en/US/docs/wireless/access_point/1300/quick/guide/br13qsg.html
Sent from Cisco Technical Support iPhone App
11-24-2011 02:16 PM
Thanks for your reply Scott.
This was working before.
This is not a new install.
Regards,
Rachna
11-24-2011 02:38 PM
Do you see a hardware error when consoled in and power cycling the bridge?
Sent from Cisco Technical Support iPhone App
11-25-2011 07:21 PM
Power off the AP, console the AP, power on the AP.
Post the entire bootup process.
11-27-2011 03:29 AM
I changed the role in the network to Root node on this brodge and the radio interfaces came up, but this device stopped talking to other network.
There is similar 1310 bridge set up in such a dierction so that it can talk to this bridge, but this is not pinging from the rest of the network.
One Small ESW-520-8P switch is connected to this 1310 bridge but the switch can be pinged from the bridge.
Does that mean it is faulty or antenna problem...
Regards,
Rachna
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide