cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
438
Views
0
Helpful
2
Replies

EIGRP Across Wireless

anthony.f
Level 1
Level 1

I have two 3550s (EMI) communicating via two 350 bridges. The logs for the 3550s continually show that connectivity is being lost. However, a telnet session across the bridges does not seem to drop. Here is one of the logged messages. How can I rid the 3550s of these messages?

May 8 14:55:48.988 EST: %DUAL-5-NBRCHANGE: IP-EIGRP 105: Neighbor 10.9.1.250 (Vlan2) is up: new adjacency

May 8 15:13:49.890 EST: %DUAL-5-NBRCHANGE: IP-EIGRP 105: Neighbor 10.9.1.250 (Vlan2) is down: holding time expired

May 8 15:14:07.390 EST: %DUAL-5-NBRCHANGE: IP-EIGRP 105: Neighbor 10.9.1.250 (Vlan2) is up: new adjacency

May 8 15:14:55.367 EST: %DUAL-5-NBRCHANGE: IP-EIGRP 105: Neighbor 10.9.1.250 (Vlan2) is down: holding time expired

May 8 15:15:16.347 EST: %DUAL-5-NBRCHANGE: IP-EIGRP 105: Neighbor 10.9.1.250 (Vlan2) is up: new adjacency

2 Replies 2

Not applicable

Assign a hold-time on the interface using the command ip hold-time eigrp

Worked just fine. :) Thank you!!!

Review Cisco Networking for a $25 gift card