embed AP in 1941 router

[Mary]

in 1941 router cdp, I can see I have a embeded AP through service module, interface wgi0/0, platform: AP801, so how can I enter the AP and see configuration for AP? thanks

[Philip D'Ath]

service-module wlan-ap 0 session

http://www.cisco.com/c/en/us/td/docs/routers/access/1900/software/configuration/guide/Software_Configuration/wlan.html

[Mary]

but I encounter below error:

1941#service-module wlan-ap0 session
% telnet connections not permitted from this terminal

my service module ip is 15.15.15.15

so how to enter into my AP#?

[Philip D'Ath]

Did you assign wlan-ap0 an IP address?

Did you telnet into the router first, and is your router configured not to allow outbound telnet connections?  Can you show the "line vty xxx" config please.

[Mary]

Thanks ,

now our router is moved to second floor, three wifi user can't connect to internet. can you advice the commands we can use to troubleshoot under AP#, thanks

[Philip D'Ath]

line vty 0 15
  transport output telnet ssh

[mohanak]

Refer link : https://supportforums.cisco.com/discussion/11203281/unable-access-embedded-ap