Wireless

Okay, any upgrade I do after 7.6 gives me this issue, be it version 8, 8.1, or 8.2.   Everything thing seems to work fine except when I look at the neighboring rogues.  Then it looks like blank entries only showing me the mac address.  If I click on ...

Hi  I have a cisco 2960x and want to know which SNMP counters are actually implemented.  According to the site below, OLD-CISCO-IP-MIB is supported and this MIB includes locIfInputQueueDrops and locIfOutputQueueDrops  ftp://ftp.cisco.com/pub/mibs/sup...

Hello, We have two APs at a remote site that are connected via FlexConnect and locally switched. I am seeing what I believe is a high amount of traffic between these two APs and my WLC. I'm hoping someone can shed some some light as to why I am seein...

Hi All, Current Scenario: We have few access points with 1 WLC (2504) in our Pakistan Office. All APs are in Local Mode and working fine. Now we have another office in India and we intend to install a couple of 2702i APs there in India Office using F...

Hi Team, Currently I am working in a medium level company,my doubt is,If is their any possibility to make single SSID for  Centrally switched and Flex local switched WLAN. All our branches are connected through MPLS. We have 3 SSID's.ER,ER-Internal,E...

Hello, on WLC with HA, I lost the connection via GUI. I have juste access to the CLI on the service port. here is Interface I got on the primary: Interface Name                   Port Vlan Id  IP Address      Type    Ap Mgr Guest------------------...

 I have a customer that want their clients to transmit at 10mW only. Is it possible to configure client tx power from the WLC?

HI, I am looking for an autonomous Cisco AP. and found this link http://www.cisco.com/c/en/us/products/wireless/buyers-guide.html#~indoorac-wave1. from here i can see 3700 and 2700 support autonomous mode. however in Cisco support forum, some are di...

hello, could you please let me know if this item AIR-ANT2524DB-R= is end of life? if yes, what the replacement part? thank you

Hi all, I just wanted to get the opinion of those who have "been there/done that" when it comes to centrally switching vs locally switching wlans. I will give as much info as i can on our wireless network design. This is for a school district with 25...

I've 2 WLCs 7510 in redundant mode and I need to dismount my redindancy because I need to convert my HA unit to a full independent WLC. Can you tell me how to do it please? I need to connect 300 APs when converted. Thanks, Ferran

Hello all, I followed the cisco procedure to go from lightweight to autonomous AP. I configured HTTP access with ip http server. I cannot log in into the AP GUI cause the AP keeps on saying AP is not in Flex connect mode (and keeps on looking via DH...

I have two WLC 2504 one as Active and the other are HA .so the installation will be N+1 .and also we have to switches 4500 using HSRP between them . i need what is the recommended design for connect both WLC to the Two cores . is the attached diagra...

Hi we migrated a customer from standalone APs to Cisco WLC (8.1). He has some devices that worked only in standalone mode, when we activated "subscriber-loop-control" on the bridge group of the wireless subinterface. When we then migrated to WLC the...