07-20-2022 08:54 AM
How can I resolve the 'Standby console disable' error I am getting when I run show commands in the CLI of the standby node after SSHing into the device successfully? I need to access the Standby device and be able to successfully run show commands. Thanks!
Solved! Go to Solution.
07-20-2022 10:18 AM
>I need to access the Standby device and be able to successfully run show commands.
Why ? The idea is that you do that on the active wlc , which will sync changes to the standbye (too)
M.
07-20-2022 10:18 AM
>I need to access the Standby device and be able to successfully run show commands.
Why ? The idea is that you do that on the active wlc , which will sync changes to the standbye (too)
M.
07-20-2022 12:25 PM
If it is a 9800 in HA following may help
redundancy
mode sso
main-cpu
standby console enable
HTH
Rasika
*** Pls rate all useful responses ***
06-04-2023 07:21 PM
Hi Rasika,
is there any impact after we config that command?
thanks,
07-10-2023 11:18 PM
Hello Ishan,
When you enable Standby Console , it will not impact any services
Your will see below during normal setup standby console disable
WLC1-stby# Standby console disabled
when you enter the command
WLC1(config)#redundancy
WLC1(config-red)#main-cpu
WLC1(config-r-mc)#standby console enable
After applying this command you notice you have enabled Console on Standby WLC
WLC1-stby#sh ver
Cisco IOS XE Software, Version 17.03.06
Thanks
Vivek
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide