02-19-2006 10:08 PM - edited 07-04-2021 11:39 AM
Dear NetPro,
i need some expert to advice, when i put encapsulation dot1q and trunk in the switch port. i totally can't get any ip address assign by Access Point. and when i remove the encapsulation dot1q and trunk. i am able to get ip . what does it mean actually ? configuration as below,
example1:
---------------------------------
int fa 2/1
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 1,210
switchport mode trunk
*************************************
Example2
----------
int fa 2/1
switchport access vlan 210
switchport mode access
***********************************
your reply will be highly appreciated,
Regards,
Jack
02-20-2006 12:44 AM
Add "switchport trunk native vlan 210" to your trunk configuration
in example 1. The (invisible) default makes VLAN 1 native, which means
frames in VLAN 210 are tagged and devices without trunk configuration
or a different native VLAN won't accept these frames.
Do you also have a dot1q-trunk configured on the AP?
02-21-2006 01:52 AM
Hi kka,
yes, i've added the "switchport trunk native vlan210" in the switch, but where do i add dot1q-trunk configured on the AP ? as i am using Aironet Access Point 1200 Series.
regards,
Jack
02-24-2006 08:40 PM
Put the IP address on the BVI1 interface and that should fix your problem. The dot1q trunking should be taking place on the subinterfaces.
02-25-2006 10:32 PM
Hi Netpro,
yes,i was put the ip address to the BV1 interface, but then i got lot of hostflapping between the switchport to switchport. mind to guide me how to solve the hostflapping issue ?
Regards,
Jack
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide