error after resetting the Cisco Aeronet 2700 access points series

[suleman.rahman05]

Initially I tried to do a hard reset but it didn't work because there were still errors and the access point wasn't working properly

then I tried to connect the access point with the internet but the lights are green and red,
does this indicate that the access point was not successful in hard reset / restore to factory settings

[Leo Laohoo]

2nd picture shows the AP not getting an IP address. 

What, exactly, are you trying to accomplish?  
Is the AP meant to be running autonomous IOS or controller-based IOS?

[suleman.rahman05]

to run autonomous IOS

[Leo Laohoo]

The 2nd picture shows the AP booting up with a controller-based IOS.  

Do you have a copy of the autonomous IOS?

[suleman.rahman05]

I don't have the copy you are referring to, so what should I do?

[Leo Laohoo]

---

@suleman.rahman05 wrote:

I don't have the copy you are referring to, so what should I do?

---

You first need to get a copy of any version of autonomous IOS.  

Without it, you cannot configure the AP.

[suleman.rahman05]

You mean Autonomous AP IOS Software

[Leo Laohoo]

---

@suleman.rahman05 wrote:

You mean Autonomous AP IOS Software

---

Yes.

[suleman.rahman05]

maybe like this

ap3g2-k9w8-tar.153-3.JPK.tar

then what is the next step?

[Leo Laohoo · Accepted solution]

---

@suleman.rahman05 wrote:

ap3g2-k9w8-tar.153-3.JPK.tar

---

The file is a controller-based IOS.  

Autonomous IOS is "w7".

[suleman.rahman05]

thank you for the solution